There are practically two ways of configuring the input shaper feature in Klipper firmware. The first is to manually print a tuning tower and measure its ringing artifacts. The second is to use an accelerometer like the ADXL345. The manual method is less accurate and more time-consuming. In contrast, using an …
How to Use an Accelerometer with Klipper (ADXL345 & More) Read More
Marlin made 3D printing more accessible, and Klipper is making it faster. One can run on basic hardware, the other needs a fast 32-bit board. One is easier to get started with, the other is easier to configure. The differences never seem to end. Klipper and Marlin have made quite an …
Klipper vs Marlin Firmware: Which is Better for 3D Printing? Read More
Klipper’s Pressure Advance feature solves several problems that affect your print quality at high speeds. Bulging corners, excessive stringing, and inaccurate dimensions are the most notable issues you’ll run into 3D printing at fast speeds. These issues often arise due to inaccurate filament pressure in the nozzle. The solution to this—adjusting …
Klipper Pressure Advance: Tuning & 5 Important Tips Read More
Until recently, if you wanted to use Klipper firmware, you had very few options. Either you’d have to set up and install the firmware yourself on a single-board computer, like a Raspberry Pi, or use a Klipper Pad that came with the firmware pre-installed. Getting a 3D printer with Klipper pre-installed …
Klipper’s input shaping is one feature that we can’t get enough of. It reduces the ringing and ghosting artifacts that occur when you print fast. No matter the print speed, it’s something that gives 3D prints smoother surfaces and reduced surface artifacts. Who doesn’t want that? However, by default Klipper does …
Klipper Input Shaping: 7 Setup Tips for the Best Results Read More
Klipper is an open-source 3D printer firmware that’s developed for high-speed 3D printing. It utilizes an additional single-board computer for extra features and improved print quality at fast print speeds. Klipper firmware is swiftly gaining popularity in the 3D printing community because of its improved feature set compared. It stands out …
Klipper Firmware: 6 Reasons to Use It for Your 3D Printer Read More
